Skip to content

Help

How the calculators work

What each tool does, the units it works in, and the engineering behind the answers.

Tank & vessel calculator

Works both ways: diameter and height from a required capacity, or capacity from dimensions you already have. Flat, ellipsoidal, torispherical, hemispherical and conical ends are all supported, and the volume of each head is added to the shell rather than ignored.

shell    V = (π/4) D² H
ellipsoidal head   V = (π/6) D² × (D/4) ... per 2:1 head
cone     V = (π/12) D³ / tan(θ/2)

The vessel-type presets set proportions and head styles only. Capacity always comes from you, because process sizing depends on residence time and throughput rather than geometry — which is why there is a throughput × residence-time helper underneath.

It also gives a shell plate take-off: the straight side expressed as rings of stock plate. Heads are excluded from that count, because a dished or conical head is pressed from a blank rather than wrapped from plate.

MS & SS plate calculator

A ring — also called a shell course — is one horizontal band of plate, rolled to the curve and welded into a circle. The sheet’s width sets its height. The calculator plans those rings rather than dividing area by sheet size.

The planner is an unbounded knapsack over ring heights, worked in tenths of a millimetre so that exact means exact. It ranks candidate stacks by:

  1. fewest rings — every horizontal seam is a circumferential weld to set up, run and test, and that costs far more than the plate it saves;
  2. least trimmed off the top;
  3. least plate bought.

It will mix at most two stock widths. Mixing is how a plan lands on an awkward height exactly — 14 ft is one 4 ft ring under two 5 ft ones, with nothing trimmed — but a yard orders plate, not arithmetic, and four different sizes on one shell is a mistake waiting to be cut.

Tick off the sizes you can actually buy and the plan only considers those. Weights are gross (what you buy, including offcut) and net (the steel in the finished tank); use gross for costing and net for foundations and lifting.

Engineering unit converter

Force, pressure, torque, power, energy, flow, velocity, area, volume, angle, length, mass and temperature, with every unit in the family shown side by side rather than one at a time. Conversion factors are exact where an exact value exists — a pound-force is exactly 4.4482216152605 N — and the standard accepted value otherwise.

Length opens on feet, because that is the unit this work is quoted in on site. The reference column below the result keeps the metric ladder in its own order so you can read across it.

A note on the PDF reports

Every calculator can write its result out as a PDF. Those are generated on your device too, with no toolkit and no font embedding, which keeps them small and quick. The trade-off is that they use the base-14 Helvetica character set, so currency symbols and non-Latin scripts cannot appear in them — money is written with its ISO code instead.

Questions

Which steel densities are used?
Mild steel 7,850 kg/m³, stainless 304 at 7,930, 316 at 8,000, 409 at 7,800 and aluminium at 2,700. References round these differently, so if your mill certificate quotes a specific value the small difference will show on a large tank.
Why does the plate calculator show two sheet counts?
Dividing total surface area by sheet area gives a theoretical floor that assumes perfect nesting and no seams — real fabrication never achieves it. The layout count builds the shell the way it is actually rolled, as horizontal rings each wrapped with whole sheets, and that is the figure to order against.