Skip to content

Runs in your browser

Gear ratio & speed

Enter the tooth count of the pinion and the gear, the input speed and torque, and the module. The calculator returns the ratio, the output speed and torque, the power in and out, the pitch diameters, the centre distance and the speed at the pitch line.

How this works →

Your figures

About 98% for a well-lubricated pair of cut spur gears; use 94–96% for a rough or worn pair.

The metric tooth size. It sets the pitch diameters and the centre distance.

Result

Ratio & speed

Gear ratio

55 ÷ 18 teeth — a reduction pair

3.056 : 1
Output speed

1,450 rpm in, divided by the ratio

474.5 rpm
Common factor of the tooth counts

Every tooth meets every other tooth in turn, which spreads wear evenly

1

Torque & power

Output torque

50 N·m × ratio × 98% efficiency

149.7 N·m
Power in

Torque × speed ÷ 9550

7.59 kW
Power out

The mesh loses 0.15 kW as heat

7.44 kW

Geometry

Pinion pitch diameter

Module × teeth

54 mm
Gear pitch diameter

Module × teeth

165 mm
Centre distance

Half the sum of the pitch diameters, for a standard pair with no profile shift

109.5 mm
Pitch-line speed

Comfortable for cut spur gears

4.1 m/s

Tooth strength, face width and lubrication are a separate calculation — this gives the kinematics and the sizes, not a safety margin.

Questions

How do I calculate a gear ratio?
Divide the teeth on the driven gear by the teeth on the driving gear. A 55-tooth gear driven by an 18-tooth pinion is a ratio of about 3.06 to 1: the output turns that many times slower and, ignoring losses, has that many times the torque.
Why does output torque go up as speed goes down?
Because power is torque times speed, and a gear pair passes power on almost unchanged. Slow the shaft down by three and the torque rises by three, less the small loss in the mesh. That is why the output end of a reduction is the end that needs the bigger shaft, key and bearings.
What is the module, and why is it needed?
The module is the metric measure of tooth size: the pitch diameter divided by the number of teeth. Two gears only mesh if they have the same module. Multiply it by the tooth count for the pitch diameter, and add the two half-diameters for the centre distance between the shafts.
Does it say whether the gears are strong enough?
No. It gives the speeds, the torque and the sizes. Whether the teeth survive depends on the face width, the material, the heat treatment, the lubrication and the load pattern, and needs a proper strength check to a standard such as ISO 6336 or AGMA 2001.