1. The service
MachineryCalc provides free engineering calculators and a unit converter that run in your browser, together with guides and articles that explain them. The tools work on your own device; what you enter in them is not uploaded to us.
2. Acceptable use
You agree not to:
- Use automated tools to scrape, mirror, or bulk-copy the site or its articles.
- Attempt to disrupt, overload, or gain unauthorised access to the site or its API.
- Send us content that is unlawful, infringing, malicious, or spam.
- Present the site's tools or text as your own, or resell them.
3. Messages you send us
If you send feedback or a request, you confirm that it is your own and that it does not infringe anyone's rights. You allow us to use it to improve the site. We may decline or remove anything at our discretion.
4. Results are estimates
The calculators are estimating aids. They turn the figures you enter into figures you would otherwise work out by hand, using the formulas and assumptions stated on each page. They are not a quotation, a drawing, or a design code. Check every result against your own drawings and the standard that applies before you order material, fabricate, or rely on it.
5. Copyright
We respond to valid infringement notices as described on our DMCA page.
6. Disclaimer of warranties
The site and its tools are provided “as is” and “as available”, without warranties of any kind, express or implied. We work to make the arithmetic correct, but we do not warrant that any result is free of error or fit for your particular purpose. See our disclaimer for detail.
7. Limitation of liability
To the maximum extent permitted by law, MachineryCalc and its operators are not liable for any indirect, incidental, or consequential damages — including loss, cost, or damage arising from a decision, purchase, or fabrication based on a result from the site.
8. Availability and changes
We may modify, suspend, or discontinue any part of the service at any time without notice. We may also update these terms; continued use after a change constitutes acceptance of the revised terms.
9. Governing law
These terms are governed by the laws of the jurisdiction in which the site operator is established, without regard to conflict-of-law rules.
10. Contact
Questions about these terms: support@MachineryCalc.com