Skip to content

Legal

Disclaimer

Plain-language notes on what this site is, what we check, and where our responsibility ends.

Last updated: July 2026

Estimating aids, not engineering sign-off

MachineryCalc gives you numbers you may put in front of a customer or a bank, so it is worth being plain about what they are. They are estimates, produced from the figures you enter and the assumptions stated on each page. They do not replace a drawing, a design code, a supplier's quotation, or the judgement of a qualified engineer.

Check before you rely on a result

Unit conversions use exact defined factors. The tank, vessel and plate calculators use standard geometric formulas, and the rate tools use anchors you set yourself — nothing is priced for you. Where a figure is a starting allowance rather than a calculation, the line says so. Compare every result with your own drawings and the standard that applies before you order material or fabricate anything.

What runs on your device

The calculators work in your browser and do not send what you enter to us. That protects your data, but it also means we cannot see or help recover a figure you lose, and speed depends on your device.

External links

Articles may link to sites we do not operate. We are not responsible for their content, availability, or privacy practices.

Editorial content

Guides and articles reflect our understanding at the time of writing. Standards, materials, and prices change; nothing here is legal, financial, or professional advice.

Rights holders

If something on this site infringes your rights, our DMCA page explains exactly what to send. You can also reach us at support@MachineryCalc.com.