Skip to content

Runs in your browser

Hydraulic cylinder force & speed

Enter the bore, the rod, the working pressure and the pump flow. The calculator returns the push and pull force, how fast the cylinder extends and retracts, how long a stroke takes, the oil each stroke moves and the hydraulic power the pump has to supply.

How this works →

Your figures

Must be smaller than the bore. Use 0 for a cylinder that only pushes, such as a ram.

The relief valve setting, or the pressure the pump really delivers at this load.

90–97% for seals and guides in good condition; lower for an old or side-loaded cylinder.

Result

Force

Push force (extend)

200 bar on 78.5 cm² of piston, at 95% efficiency

149.2 kN · 15.22 tf
Pull force (retract)

The rod takes 24.6 cm² off the piston, so 53.9 cm² is left to pull on

102.4 kN · 10.44 tf
Area ratio

Extending is this many times stronger, and retracting this many times faster, at the same flow

1.46 : 1

Speed & time

Extend speed

30 L/min into 78.5 cm²

63.7 mm/s
Retract speed

The same flow into 53.9 cm²

92.7 mm/s
Extend time

500 mm stroke

7.9 s
Retract time

500 mm stroke

5.4 s

Oil & power

Oil to extend

Piston area × stroke

3.93 L
Oil to retract

Rod-side area × stroke

2.7 L
Hydraulic power

Pressure × flow ÷ 600 — the motor must supply more, to cover pump losses

10 kW

A long stroke on a slim rod needs a buckling check, and the seals and the mounting must be rated for this pressure. This does neither.

Questions

How is the force of a hydraulic cylinder worked out?
Force is pressure times the area it acts on. On the push stroke the oil pushes on the whole piston, so the area is pi over four times the bore squared. At 200 bar on a 100 mm bore that is about 157 kN before losses; the calculator then takes the mechanical efficiency off, for seal friction and guides.
Why is the pull force smaller than the push force?
Because the rod is in the way. On the retract stroke the oil acts on the ring of piston left around the rod, not on the whole face, so the force is lower by the rod's area. The same fact works the other way for speed: with the same flow into a smaller area, the cylinder retracts faster than it extends.
Which pressure should I enter?
The pressure the cylinder really sees at this load, which can be lower than the relief valve setting. If you only know the relief setting, enter that and treat the result as the most the cylinder can push. A load that needs less than that pressure will not develop the full force.
Does it check that the cylinder is strong enough?
No. It gives the force and the speed. A long stroke on a slim rod can buckle well below the force shown, and the cylinder tube, the seals, the rod end and the mounting all have their own pressure and load ratings. Check those against the maker's data, and add a buckling check for long strokes.