Skip to content

Runs in your browser

Welding cost estimator

Enter the weld length, the joint and its size, the welding process and your prices. The calculator returns the weight of weld metal, how much rod or wire to buy, the arc time and the total time, and the cost, in total and per metre of weld.

How this works →

Your figures

The leg of a fillet, or the plate thickness for a V butt weld (60° groove, 2 mm root gap).

Rod or wire, in your own currency.

The welder's wage plus the share of the shop that comes with the hour.

The share of the working hour the arc is actually burning. Hand welding is often 25–40%, mechanised welding 60% or more.

Shielding gas and electricity for each hour the arc burns. Use 0 for stick welding.

Result

Material

Weld cross-section

Half the leg squared, plus 15% for the convex face

36.8 mm²
Weld metal

20 m of weld at 7.85 g/cm³

5.78 kg
Consumable to buy

93% of this process's rod or wire ends up in the weld

6.21 kg

Time

Arc time

3.5 kg of weld metal per hour with the arc on

1.7 h
Total time

Arc time ÷ 30% arc-on

5.5 h

Cost

Consumables

6.21 kg × 4

24.85
Labour and overhead

5.5 h × 10

55.02
Gas and power

1.7 arc hours × 1.5

2.48
Total cost
82.35
Cost per metre of weld

The figure to quote against

4.12

Figures are in whatever currency you entered. They cover welding only — preparation, tacking, grinding, inspection and rework are not included.

Questions

How is the weight of a weld worked out?
From the cross-section of the weld, the length and the density of steel. A fillet weld's section is half the leg size squared; a V butt weld's depends on the plate thickness, the groove angle and the root gap. A 15 percent allowance is added for the cap on the weld, which is never flat.
Why do I need to buy more consumable than the weld weighs?
Because not all of the rod or wire ends up in the joint. Stick welding loses the stub and a lot of spatter, so only about 60 percent of the rod ends up as weld metal; MIG wire reaches 93 percent; submerged arc is close to 99 percent. The calculator divides the weld weight by that efficiency.
What does arc-on time mean?
It is the share of the working hour that the arc is actually burning. The rest goes on fitting up, moving, changing rods, chipping and grinding. Hand welding is often 25 to 40 percent; mechanised welding is 60 percent or more. A low figure is the main reason a welding job costs more than the wire suggests.
What does the estimate leave out?
It covers the welding itself: the rod or wire, the time at the weld and the gas and power. Cutting and preparing the edges, fitting and tacking, preheat, grinding, inspection, testing and any rework are not included, and they can add as much again on critical work.