Skip to content

Runs in your browser

CNC speed & feed

Enter the cutting speed the tool maker recommends, the cutter diameter and flutes, the feed per tooth and the depth and width of cut. The calculator returns the spindle speed, the feed rate, the volume of metal removed per minute and the power the cut takes.

How this works →

Your figures

Sets the cutting force used for the power figure. It does not change the speed — you choose that below.

Carbide tools, roughly: steel 120–200, stainless 80–140, aluminium 300–600, cast iron 100–180, brass 150–300, titanium 40–70. The tool maker's table wins.

The chip each tooth takes: about 0.02–0.05 for small cutters, 0.08–0.15 for large ones.

If the speed you ask for is above this, the machine runs at its limit and the cutting speed drops.

Result

Spindle & feed

Spindle speed

1000 × cutting speed ÷ (π × diameter)

3,979 rpm
Feed rate

0.2 mm per revolution (4 flutes × 0.05 mm)

796 mm/min
Cutting speed reached

As entered

150 m/min

Removal & power

Material removal rate

Width × depth × feed rate

23.9 cm³/min
Cutting power

Removal rate × 2,000 N/mm² cutting force for this material

0.8 kW
Spindle power needed

Cutting power ÷ 0.75 for drive and spindle losses

1.06 kW

A starting point, not a guarantee. Tool stickout, workholding, chip evacuation and the machine's rigidity decide what it will really take — begin below these figures and work up.

Questions

How do I turn cutting speed into spindle speed?
Multiply the cutting speed in metres per minute by 1000 and divide by pi times the cutter diameter in millimetres. A 12 mm cutter at 150 m/min runs at about 3,980 rpm. A smaller cutter has to turn faster to reach the same speed at the edge.
What is feed per tooth, and how is the feed rate found?
Feed per tooth is the thickness of the chip each cutting edge takes on each turn. Multiply it by the number of flutes for the feed per revolution, then by the spindle speed for the feed rate in millimetres per minute. Too little feed rubs and wears the edge; too much overloads it.
Why does the calculator mention a spindle limit?
Small cutters need very high speeds to reach a good cutting speed, and many machines top out below that. When that happens the machine runs at its limit, the real cutting speed is lower than you asked for, and the feed rate is worked out from the speed it can actually reach.
Can I trust the cutting power figure?
Treat it as an estimate. It uses a typical cutting force for the material, and the real value moves with the grade, the tool geometry, the sharpness and the chip thickness. It is useful for checking that a cut is within a spindle's power, not for promising a result. Start below the figures and work up.